25
www.longer3d.com info@longer3d.com
is between 20 to 100μm.
Advanced Setting: set the layer number of base plate to strong
the adhesion between model and building platform, the
height of base is about 0.3mm, so the layer number is set to 6
when the layer thickness is 50μm; and sets to 3 layers when
layer thickness is 100μm. 5. It is recommended to add plate
players to facilitate removing the model. It has to add base
plate if the bottom surface of the model and the building
platform hasn’t an enough contact surface to cohere the
model or there are many support points on the building
platform.
Slice: slice the model with the setting layer thickness, “sliced”
will show when it is completed otherwise is shown “not slice”.
And there is a prompt of “slicing the scene” in the upper right
corner of the software when slice the model.
Slicing Image Preview: preview the image of sliced model by
drag the slider as shown in forth arrow.
Adjust the layer thickness to suitable value by clicking left and
right arrow , such as 50μm, click slice icon to slice the model
by setting layer-thickness. Every layer image can be previewed
in the window by dragging the slider in the bottom or input
the number of layer in the blank.
To Next Page
Loading...
