27
www.longer3d.com info@longer3d.com
the model and building platform. The default time is 80000ms.
Stable Time: the time between stop motion of Z axis and LCD
projection. The default time is 1000ms
Burn-in range: the height that is over cured for increasing the
adhesion between the models and building platform. The
default value is 0.3mm.
Lift Distance1: the slow motion distance for separation. The
default distance value is 2mm.
Lift Speed1: the separation speed for slow motion range. The
default speed is 48mm/min. It can decrease the separation
force by adjusting the value to 30mm/min for the model with
fine size.
Lift Distance2: the fast motion distance for separation, and it is
a relative distance to Lift Diantance1. Defaulted value is 2mm.
Lift Speed2: the separation speed for fast motion range,
Defaulted value is 300mm/min.
Select the corresponding printing parameters from the list
according to the layer thickness shown at the bottom. There
are three defaulted recipes respectively for 25, 50, 100μm layer
To Next Page
Loading...
