www.longer3d.com 1 info@longer3d.com
Important Notice
1. Make sure there is no model under building plate
or in the resin tank by a paper card before each
printing and leveling. Otherwise, it will cause
damage to the printer.
2. Do not remove the USB Disk during printing.
3. Do not scape the resin tank by sharp plastic or
metal knife, it may cause film damage and resin
leakage.
4. Please take care of the metal scrapper to avoid
injury during removing the model.
5. It is recommended to add plate players to
facilitate removing the model.
6. Please dispose of the resin waste liquid according
to local regulations, and do not pour directly into
the domestic drainage channel.
To Next Page
Loading...
