www.longer3d.com 25 info@longer3d.com
Shaft Diameter: the diameter of support column, the larger
value, the stronger support, but more difficult to remove. The
suggested value is about 1.1.
Lift Distance: the distance between the model and building
platform is lifted by generating support. The suggested value
is between 0 to 3mm.
Default: recover support parameters to original values.
Make a copy of supported model: select the model with
support, click Edit icon, then click clone icon.
6.9 Slice
Thickness: the current layer thickness of printing model.
Thickness Setting: set the layer thickness, the suggested value
is between 25 to 100μm.
To Next Page
Loading...
