LONGER Orange30 - Accessory Box and Initial Setup; Initial Activation Steps

www.longer3d.com 5 info@longer3d.com
3.2 The accessory box
Power Adapter1
Filtering Funnel2
Latex Gloves2
Fixture4
Scraper1
Photopolymer Resin
250g1
Card5
Release Film1
Hexagon Wrench 1.5mm
Hexagon Wrench 2mm
Hexagon Wrench 2.5mm
Hexagon Wrench 3mm
Card Reader1
Clean Wiper1
4. Active Your 3D Printer
Put the printer on a flat platform. Make sure that the printer is
stable. Connect power cable and power adapter. Plug into the
electronic power and switch on the printer.