www.longer3d.com 29 info@longer3d.com
Lift Speed1: the separation speed for slow motion range. The
default speed is 48mm/min. It can decrease the separation
force by adjusting the value to 30mm/min for the model with
fine size.
Lift Distance2: the fast motion distance for separation, and it is
a relative distance to Lift Diantance1. Defaulted value is 2mm.
Lift Speed2: the separation speed for fast motion range,
Defaulted value is 300mm/min.
Select the corresponding printing parameters from the list
according to the layer thickness shown at the bottom. There
are three defaulted recipes respectively for 25, 50, 100μm layer
thickness which cannot be edit and deleted. Click save job
button to generate a printing job file with a file suffix of lgs.
The software generates and saves the printing job file to a
folder with the same name and directory with the model. And
there is a prompt of “saving slice file” in the upper right corner
of the software when save the job.
New/edit recipe: create or edit a new recipe and a recipe edit
menu appears as shown below. It can edit the parameters by
To Next Page
Loading...
