4.19 Replacing (lower) door seal
Prerequisite:
Appliance is disconnected from power supply.
Appliance is disconnected from water supply.
Outer door has been removed.
Base socket plate has been removed.→Page 233
Toe panel has been removed (optional).→Page 232
Door springs have been removed.
Control panel has been removed.
Cable harness holder on bottom right has been removed.
4.19.1 Removing the door seal
1. Remove the two retaining clips on the lower door seal (1, 2).
2. Detach the overflow channel.
3. Lift the overflow gutter off.
Repair
To Next Page
Loading...
Need help?
General
