EasyManuals Logo

LORD D1 User Manual

LORD D1
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
4.20 Replacing (upper) door seal
Prerequisite:
Appliance is disconnected from power supply.
Appliance is disconnected from water supply.
4.20.1 Removing door seal
Remove door seal from inner frame.
4.20.2 Installing door seal
The door seal must be cut to the correct length before installation. This is 1750 mm for
appliances of 81 cm in height and 1850 mm for appliances of 86 cm in height.
1. Prepare appropriate door seal.
2. Ensure correct installation position of sealing profile.
3. White dot must be on level with sealing bed strip.
4.
Sealing must not be wavy or stretched at corners. Seal is cut off di-
agonally at ends and tapers away into bottom of container at front.
Position end of seal straight to front underneath inner door. Seal should lie against
side of container as far as possible.
Correctly installed door seal:
Repair

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LORD D1 and is the answer not in the manual?

LORD D1 Specifications

General IconGeneral
BrandLORD
ModelD1
CategoryDishwasher
LanguageEnglish

Related product manuals