Using the Main Menu14
CAUTION
P2P connection is the primary method used for remote access to your security system using the Lorex Home app.
If you disable P2P connectivity, you will only be able to access your system over the Internet using DDNS. See 20
DDNS Setup (Advanced), page 96 for details.
To change P2P setting:
1. From the Live View display, right-click to open the Quick Menu, then click Main Menu.
2. Click NETWORK, then click the P2P SETTING tab.
3. Click to enable ( ) / disable ( ) P2P connectivity.
4. Click Apply.
14.7 System
Configure general system settings, such as date & time, time zone, and DST. It also allows you to
check for firmware updates over the Internet and restore the system to default settings.
14.7.1 Configuring General System Settings
Configure miscellaneous system settings.
To configure general system settings:
1. From the Live View display, right-click to open the Quick Menu, then click Main Menu.
2. Click SYSTEM. Click the GENERAL tab on the side panel, then General on the top panel.
#LX400111; r. 1.0/55872/56018; en-US 64
To Next Page
Loading...
Need help?
General