9
Basic Setup
Step 6: Upgrade Firmware to Latest Version (if Available)
If a firmware upgrade is available, you will be asked to install it once the DVR starts up. It
is required to upgrade your system to the latest firmware version to enable remote
connection to the system.
If a firmware upgrade is available:
1 Aft
er startup, a notification will appear asking you to upgrade the firmware. Click Yes to
upgrade.
2 Ent
er the system user name (default: admin) and password (default: 000000) and click Apply.
Wait for the firmware update to complete. The system will restart once the firmware has been
upgraded.
Step 7: Verify Camera Image
• Power on the cameras, and then verify the camera video quality before mounting the cameras
to a permanent location.
• Mount the cameras under a sheltered location. Always verify the outdoor rating of your camera
bef
ore installing it in a permanent location.
Step 8: Set the Time
• Set the system time and date for accurate video time stamps. Videos with inaccurate times
may not be valid as surveillance evidence.
• For details on setting the system time, see “Setting the Date and Time” on page 21.
Click Yes to upgrade
the firmware
DO NOT POWER OFF THE UNIT OR DISCONNECT THE POWER
CABLE DURING FIRMWARE INSTALLATION
To Next Page
Loading...
Need help?
General