EasyManuals Logo

Lorex LH156 User Manual

Lorex LH156
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
38
Using the Main Menu
3 In the Covert drop-down menu, select
Enable.
4 Cl
ick Apply to save your settings.
Configuring the Time and
Recording Time Display
To add/remove the time stamp in the
system display:
1 In the Li
ve Time and Record Time
drop-down menu, select enable or
disable.
2 Cl
ick Apply to save your settings.
Configuring Sequence Time
Sequence time refers to the amount of
time a channel appears on the screen
before changing to a different channel
when the DVR is in Sequence Mode. For
example, when Sequence Mode is on,
channel 1 is shown for several seconds
before switching to channel 2.
To configure the sequence time:
1 Click the Output ta
b.
2 Cl
ick the SEQ Dwell time field and enter
the time channels remains on-screen
before changing to another channel.
3 Cl
ick Apply to save your settings.
Changing the Video-out Resolution
1 Click the Output tab.
2 Click the
drop-down menu beside VGA/
HDMI Resolution and select the output
resolution.
3 Click Appl
y to save your settings.
4 Right-click r
epeatedly to exit all menus.
The DVR prompts you to restart. Click OK.
5 The D
VR restarts and asks you to confirm
the new resolution. Click Yes to confirm or
No to revert to the old resolution. If you do
nothing, the DVR will revert to the last
selected resolution and restart.
NOTE: If
you select a resolution that is
greater than what your monitor
supports, you may see a blank
screen when your DVR restarts. If
this occurs, do not do anything and
wait until the DVR restarts. If the
screen remains blank, press and
hold the Stop button (
) on the front
panel of the DVR until the DVR
restarts. Your system resolution will
default to 1024 x 768.
Restoring the System’s Resolution
if you see a Blank Screen
If you see a blank screen on your
monitor after turning on your system,
the DVR’s output resolution may be
higher than what your monitor
supports. Follow the steps below to
restore the DVR’s default resolution to
1024 x 768.
To restore the DVR’s default
re
solution:
1 Ensur
e the power and video cables are
properly connected.
2 Pr
ess and hold the Stop button () on the
front panel of the DVR until the DVR
restarts. The DVR will restart with the
default resolution of 1024 x 768.
SEQ Dwell time
Stop button ()

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lorex LH156 and is the answer not in the manual?

Lorex LH156 Specifications

General IconGeneral
BrandLorex
ModelLH156
CategoryDVR
LanguageEnglish

Related product manuals