Lorex N842A82 - Searching for Person & Vehicle Detection Events (Smart Search)

Smart Motion Detection14
◦ Click OK when finished.
5. If you choose to flash the camera’s warning light when a person or vehicle is detected, con-
figure the following warning light options:
• Duration: Enter the time in seconds the warning light will remain on after a person or ve-
hicle is detected.
• Warning Light / Strobe: Choose Warning Light to use a solid white light, or Strobe
for a flashing light. If you select Strobe, choose the Strobe Frequency to determine how
quickly the warning light will flash when triggered.
6. Click Apply.
14.3 Searching for Person & Vehicle Detection Events (Smart Search)
Smart Search lets you filter recorded video to search for person detection events, vehicle detec-
tion events, or both.
NOTE
In order to use Smart Search, you must configure at least one channel’s smart detection settings. See the proce-
dure above for full instructions.
To perform a Smart Search:
1. From the Live View display, right-click to open the Quick Menu, then click Main Menu.
2. Click EVENTS. Click the Smart Search tab on the side panel, then in the drop-down click
Smart Motion.
3. Select a channel to search for detection events from, or select All.
4. Enter a start and end time for your search.
5. Next to Event Type, select Person, Vehicle, or All.
#LX400113; r. 9.0/57192/57197; en-US 47