Lorex Vantage LH020 Blackbox 2 - Using the PTZ Menu (Local DVR); PTZ Presets and PTZ Cruise; Setting PTZ Presets

104
Appendix B: Connecting a PTZ Camera
3 Configure the following according to your PTZ
camera’s specifications:
• Channel: Select the channel the PTZ camera
is connected to.
• Protocol: Sel
ect from Pelco-D or Pelco-P.
• Baud rate:
Select the PTZ camera’s baud rate.
• Data Bit: Sel
ect from 5~8 data bits.
• Stop Bit: Select
from 1 or 2 stop bits.
• Parity: Sel
ect from None, Odd, Even, Mark or
Space.
• Cruise: Sel
ect Enable to enable PTZ cruise.
• Address: Enter the PTZ camera’s address.
4 Click A
pply to save your settings.
Using the PTZ Menu (Local DVR)
To control the PTZ camera locally on your DVR:
1 Select the channel that the PTZ camera is connected to.
2 Right-click and press the PTZ button (
). Enter the system password. The PTZ menu
opens.
3 Use the on-screen PTZ controls to control the camera.
Channel: 
Select the channel the PTZ
camera connects to.
Click the + and - symbols to
adjust the camera Zoom,
Focus and Iris settings
Direction keys: 
Click to pan and tilt the camera
Speed Slider:
Increase or decrease the pan and tilt speed
Camera Pre-set
controls
PTZ Presets and PTZ Cruise
You can set preset positions for your PTZ cameras. You can also use PTZ cruise to have the
camera automatically cycle through presets.
Setting PTZ Presets
1 Using the PTZ controls, move the camera into position.