79
Using the PC/Mac Client Software
3 Beside Upgrade File Path, click the browse button ( ). Locate the firmware, and click
Open.
4 Cl
ick Start t
o begin the firmware upgrade.
5 Follow the on-screen instructions to complete the firmware upgrade.
NOTE: Your system may have to restart after a firmware upgrade.
Restoring Default Settings
To restore the system’s system defaults:
1 Click the Remote Setting tab, and
click Advanced>Load Default.
2 Select the menus that you wish to restore to factory defaults.
3 Click Sav
e to restore system defaults for the selected items.
Configuring Event Settings
The Event Settings tab allows you to configure how the system behaves when a system
event occurs (e.g. hard drive error, video loss). This is useful if you want your DVR to notify
you if there is a potential system problem.
To configure the system event settings:
1 Cl
ick the Remote Setting tab, and
click Advanced>Events.
2 Configure the following:
• Event Type: Configur
e the type of event that triggers the system to send an alert.
• Enable: Sel
ect Enable to activate the system to notify you if an event occurs.
To Next Page
Loading...
