52
Using the Main Menu
7 Right-click until you have exited all menus.
The DVR prompts you to restart.
Restarting or Shutting Down the
DVR
To restart or shut down the DVR:
1 Right-click to open the Menu Bar and click
the
Main Menu button (
).
2 Click Ad
vanced.
3 Click Re
boot or Shut Down.
4 Follow the on-screen instructions to
restart or shut down your system.
Configuring System Warnings
The system can send out email
notifications, or trigger a connected
alarm device (not included; 16-channel
models only) if it detects system
abnormalities. For example, the system
can send out a warning if the hard drive
is low on storage.
To configure system warnings:
1 Click the Events
tab.
2 Configure the
following:
• Event Type: Sel
ect the event that triggers
the system to send out a notification or
alarm trigger. Choose from Disk No Space
(low hard drive space), Disk Error (hard
drive error), or Video Loss.
• Enable: Sel
ect Enable or Disable to
activate or deactivate the system from
sending out notifications.
• Alarm Out: Sel
ect the checkbox to enable
alarm out devices (not included;
16-channel only) from triggering.
• Show Message: S
elect the checkbox for
the system to display an error message
when an event occurs.
• Send Email: Sel
ect the checkbox for the
system to send out email notifications
when a system error occurs. Note, email
notifications must be configured.
• Latch Time: Sele
ct the delay duration in
the drop-down menu.
• Buzzer:
Select the buzzer (system beep)
duration when the system detects a
system error.
3 Click Appl
y
to save your settings.
Saving Your System Configuration
to a USB Flash Drive
The DVR allows you to save your current
system configuration to a USB flash
drive (not included). This is useful if you
To Next Page
Loading...
