Chapter 7 Built-in High-speed Counter Function
XBC E-Type Main Unit 7-10 Ver. 1
iv. During decreasing count
I. Even if count value exceeds user-defined minimum value during
decreasing count, Borrow only occurs and count does not stop
differently to Linear Count.
v. Operation when setting Ring Count based on present count value (during
increasing count)
I. If present count value exceeds user-defined range when setting Ring
Count
a. Error (code no. 27) is occurred and it operates linear counter.
II. If present count value is within user-defined range when setting Ring
Count
a. Present count value starts to increase up to the user-defined
maximum value and down to the user-defined minimum value
and keeps counting after Carry occurs.
III. Not the maximum but the minimum value only is displayed with count
kept on as shown below.
※If within the user-defined range
※If out of the user-defined
range
To Next Page
Loading...
