4 -5
Position control
lever
Throttle pedal
Clutch pedal
Brake pedals
Power shuttle lever
Throttle lever
Parking brake
lever
Main gear
shift lever
1. Lift up all the implements
(front/middle/rear) from the ground
after starting engine.
2. Pull throttle lever to low speed
position.
3. Place power-shuttle lever in
neutral position.
4. Place each transmission gear
lever (Main, Range, Creeper lever)
on a suitable position.
5. Press brake pedals and release
the parking brake lever.
6. Place power-shuttle lever to
forward or reverse position, and
press throttle pedal slowly when
the vehicle begins to start.
▶When starting power-shuttle model normally, use power-shuttle lever without
depressing clutch pedal.
Notice
To Next Page
Loading...
