3 -39
Position control lever
Draft control lever
(3) Hydraulic lift Control (Mechanical Hydraulic Lift, MHL)
The hydraulic lift system is operated by the position control and draft control lever.
Down speed control valve
① Position control
To set the position (height) of the rear implement,
move the position control lever up/down during
the engine is running. Generally, this lever is
used for tiller, fertilizer distributor, mower, rake
and other rear implements.
1.Push the position control lever forward and let
the implement down by its own weight.
2.Move up the lever to desired position, the rear
implement shell be located on the position
corresponding to the lever position.
3.To set the lowest position of the lever, turn
stopper A counter-clockwise, move and tighten it
at the desired position.
Position control
lever
Up
Down
To Next Page
Loading...
