3 -18
(11) Beacon lamp switch (if fitted)
It is used to turn on/off the beacon lamp connected to beacon connectors. The beacon connectors
are installed on the left and right-hand side under the cabin roof.
ON - press upper side of the switch.
OFF - press lower side of the switch.
Beacon lamp switch
540E PTO switch
Beacon connector
(12) 540E PTO switch (if fitted)
It is used to turn on/off the 540E PTO operation
mode when working in the field.
In this mode, the engine maximum speed shall
be restricted up to the designated engine speed
related to the 540 PTO speed for economic PTO
operation.
When the PTO gear lever is in 750/540E rpm
position and the PTO switch is turned on, if
pressing this switch to “ON” position, the 540E
PTO mode is ready.
ON - press the upper side of the switch.
OFF - press the lower side of the switch.
▶ If placing the PTO switch or 540E PTO switch to “OFF” position or placing the PTO
gear lever to other position except 750/540E position while the engine maximum
speed is restricted, The 540E PTO mode may be exited and the engine speed can
be suddenly increased.
▶ Before exiting the 540E PTO mode, lower the engine speed to idle rpm.
Caution
To Next Page
Loading...
Need help?
General
