3 -55
Up
Down
(3) External up/down switch (EHL)
① External lift up/down switch (EHL)
This switch is attached on the rear mudguard.
This is used to attach or detach the implement
to the 3-point linkage.
1. If pressing and holding the switch up/down,
the implement will lift up/down with beep sounds.
2. If the implement is not attached, the 3-point
linkage lets down very slowly due to oil viscosity
resistance. In this case, press the lower link
down.
▶ According to the ambient temperature, the lift up/down speed of the implement
may be changed.
▶ Do not press and hold this switch over 20 seconds. If so, the error diagnostic code
shall be displayed on the instrument panel. BE CAREFUL !
Notice
▶DO NOT operate the switch with standing between tractor and rear implement.
The operator must only activate the external switch while standing to the side of the
tractor.
▶Never extend arms, any part of the body or any object into the area near the 3-point
linkage while operating the external up/down switch.
Caution
To Next Page
Loading...
