5 -13
Brake pedals
(11) Adjustment of Brake pedal
play
Normal distance : 20~40mm. (0.7~1.6 in.)
If the pedal play distance is over 40mm (1.6 in.),
adjust it as below.
1. Loosen the locking nut and turn brake rod to
adjust.
2. If tightening the brake rod, the pedal play shall
be increased, and if loosening, it shall be
reduced.
3. Pay attention that brake rod does NOT push the
piston of brake master cylinder when brake pedal
is released.
4. After adjusting the pedal play, tighten the locking
nut.
5. Check if the brake distance of the left and right
brake is same as below.
Checking the brake distance
1. Connect left and right brake pedal using
connecting pin.
2. Check the skid mark of the tire or stability of the
tractor while driving at a suitable speed.
3. If the brake distance is different as shown in the
right figure, adjust the pedal play again.
Left/ Right brake distance
is different.
Normal
Brake rod
If you need more adjustment for clutch pedal play, check the oil level and bleed air from the clutch
pedal oil line. (See page 5-32)
② Power shuttle (PSS)
In case of power shuttle models, an electric sensor to control the power shuttle clutch pack is
attached and tuned specially on the clutch pedal linkage system.
If this linkage system is changed or modified arbitrary, it may cause a serious fault or malfunction to
the power shuttle clutch pack.
The air-bleeding of the power shuttle clutch pedal system is NOT needed.
If you need any service for power shuttle system, do not hesitate to contact your authorized local
dealer for check.
To Next Page
Loading...
Need help?
General
