LS U5020 - Range Gear Shift Lever; Creeper Gear Lever (if Fitted); PTO Gear Lever

(8) Range gear shift lever
 4 stage speed selection is available.
 Front is for 1
st
and 2
nd
gear, middle for neutral and
rear for 3
rd
and 4
th
gear.
 Range gear shift lever must be operated after the
tractor has stopped completely.
(9) Creeper gear lever (if fitted)
 If you pull this lever upward, the creeper gear
stage is connected (ON), and if you pull it back
Range gear shift lever
2nd
3rd
Neutral
4th
1st
stage is connected (ON), and if you pull it back
down, the creeper is disengaged. (OFF)
▶ As the revolution force of wheel
axle is very high when working
in creeper speed range, the
machine may not stop even if
you press the brake pedals.
In this case, press the clutch
pedal to cut off the power and
operate the brake pedals.
Caution
Creeper gear lever
Creeper range
Standard
(10) PTO gear lever (if fitted)
 540 / 750 / 1000 rev/min and 'Neutral ' position is
available.
3
3 3
3 - 11
available.
PTO gear
lever
▶ After putting PTO switch in 'OFF' and PTO shaft has stopped completely, place the
lever to desired position. (See page 3-12)
▶ If the PTO gear lever is NOT engaged smoothly, lift up and down on implement to
align the drive shaft.
Caution