(2) Changing Transmission oil
5-9. Every 600 hour check
(1) Changing Front axle oil
Loosen the left/right drain plug and drain the oil.
Attach sealant tape to the left/right drain plug and
tighten completely.
Inject new oil into the injection inlet.
Normal capacity : 10 ℓ (2.6gal)
Drain plug
Injection inlet
Loosen the clutch or housing drain plug under
the axle housing and drain the oil completely.
Clean the metal powder attached to the drain
plug.
Insert the copper washer to the plug and tighten
it completely.
Inject the oil as much as the oil level stays
between low limit and high limit.
Normal capacity : 47 ℓ (12.4gal)
▶
The contaminated oil may reduce the durability of transmission and cause the
failure of hydraulic system. Clean around oil filling port and then open the cap.
Warning
Oil inlet
Drain plug
5
5 5
5 - 19
To Next Page
Loading...
