(11) PTO mode switch
It is used to select “AUTO” or “'Manual” mode of
PTO operation
When the PTO mode switch is placed on “AUTO”
position, if you press the clutch pedal or the
‘position control lever’ moves up the arranged
position during operation, the PTO will not rotate.
If it is placed on “MANUAL” position, the PTO will
rotate.
(12) PTO switch
PTO switch
PTO MODE
switch
PTO switch
The engine starts only when PTO switch is
placed in 'OFF‘ position for safety.
After starting the engine, you must comply with
the operation procedure of the PTO switch as
follow.
1. Place the PTO gear lever to desired position.
(For further information, See page 3-11)
2. Select the PTO mode switch to ‘AUTO’ or
'Manual' position.
3. Push and turn the PTO switch to engage PTO.
the PTO operation indicator shall be ON
4. If you want to stop the PTO temporarily while
operating, push the PTO switch in 'OFF' position.
The PTO operation shall be OFF.
ON : PUSH AND TURN
OFF : PUSH
PTO operation
indicator
3
3 3
3 - 12
▶
Before attaching or checking the PTO driven equipment,
- Always place the PTO switch in 'OFF' position, and PTO gear lever in 'Neutral'
position.
▶
If the PTO mode switch is placed in 'Manual' position, PTO rotates even if the
tractor moves backward. Pay attention to the surroundings to prevent a accident.
▶
Do not engage the PTO with the engine running at high speed. Sudden
engagement can cause damage to some implements. Engage PTO at low RPM,
and then raise engine speed to rated RPM.
Warning
To Next Page
Loading...
