LS U5020 - Attaching Equipment

(1) 3-point linkage
4-4. Attaching equipment
③
④
⑤
 When running without attaching implements, carry out the followings.
1. Fix upper link(5) to the fastening hook of auxiliary hydraulic pipe bracket.
2. Connect stabilizer(2) to lower link(3) so that the lower link is not moved to the left or right side
 When working without using 3-point linkage like trailer working, remove the 3-point linkage as below.
1. Remove upper link(5).
2. Draw lift rod pin(6). (left, right)
3. Detach the fixed part of stabilizer(2). (left, right)
4. Detach the fixed part of lower link(3). (left, right)
※
3
-
point linkage must be fixed on the suitable position according to the weight of implements to be
1. Lift rod (RH) 3. Lower link 5. Upper link
2. Stabilizer 4. Lift rod (LH) 6. Lift rod pin
①
② ⑥
4
4 4
4 - 8
※
3
-
point linkage must be fixed on the suitable position according to the weight of implements to be
attached.
Warning
▶ Before attaching/detaching implements, place PTO switch in ‘OFF’ position and
PTO gear lever in ‘Neutral’ ,and apply the parking brake.
▶ When attaching/detaching implements, make sure to assemble and tighten the
connecting parts correctly.
▶ if the tractor is used to tow heavy loads, always use the approved drawbar or hitch
to avoid injury. Never connect to lower link or upper link of 3-point linkage. If not, it
may cause tipping or turnover.
▶ DO NOT connect the implements that require more power than can be generated
by your tractor.
▶ Never stand between implement and tractor hen backing up.