LS U5020 - How to Drive and Stop

1. Pull the position control lever back
to lift the implement up after starting
engine.
2. Fix the engine rpm at 1500 RPM
Position control
lever
4-2. How to drive and how to stop
(1) How to drive
3. Press the clutch pedal completely
4. Place each gear lever (Main,
Range, Shuttle lever) on the desired
position.
5. Press the brake pedal and release
Throttle pedal
Brake pedal
F/R shuttle lever
Clutch pedal
4WD lever
Throttle lever
Main gear
Parking brake
GSP lever
(if fitted)
4
4 4
4 - 3
5. Press the brake pedal and release
the parking brake lever.
6. Release the clutch pedal slowly
and the tractor starts.
▶ Release the clutch pedal slowly.
If you release the clutch pedal suddenly, the gear life shall be reduced and it may
cause a sudden start.
Notice
Range gear
shift lever
Main gear
shift lever
Parking brake
lever
Creeper gear
lever (if fitted)