①
①①
① Position control
This mode sets the position of the implements
freely by position control lever operation.
Generally, this mode is used for tiller, fertilizer
distributor, mower, rake etc. In this case, operate
position control lever as follows.
1.Push the position control lever forward and the
implement lets down by its own weight.
2.If the position control lever is on random position,
the implement stops at the height corresponding
to the lever position.
3.To keep the height of implement in the desired
range, restrict the lever to the lowest position
Stopper A
Stopper AStopper A
Stopper A
Position
control
lever
Up
Down
range, restrict the lever to the lowest position
with stopper A.
②
②②
② Draft control
This mode maintains the load of the implement
consistently by detecting the draft load and
transmitting it to the hydraulic valve. Generally, this
mode is used for the implement which receives the
draft load.
In this case, operate the lever as follows.
1.Remove the draft sensor stopper of upper link
bracket.
2.Move the position control lever forward fully (Down)
and the implement lets down by its own weight.
3.The volume of load that the hydraulic valve receives
shall be determined according to the position of
In working by
draft control
In working by position control
Draft sensor
stopper
Stopper A
Stopper AStopper A
Stopper A
shall be determined according to the position of
draft control lever.
That is, the more the lever moves back (up), the
more the implement rises up just by a little draft
load.
4.If you want to lift the implement, use the
position control lever instead of draft control lever
③
③③
③ Mixed control
This mode uses both position and draft control lever. In this case, the position of implement is
controlled by the position control lever and the traction load is controlled by the draft control lever.
Stopper B
Stopper BStopper B
Stopper B
Up
Up`
To Next Page
Loading...
