LSIS Master-K K1000S - Example of Programming; System Configuration; Initial Setting

Chapter 15 The PID function of K200S MASTER-K
15-23
15.5 Example of programming
15.5.1 System configuration
15.5.2 Initial setting
1) PID operation parameters
④ Auto / Manual operation setting : Auto
⑤ Forward / Reverse operation : Forward
⑥ SV setting : 1600 (100°C)
⑦ BIAS setting : 0 (If only P control is used, input proper value
other 0)
⑧ EN_P, EN_I, EN_D setting : EN_P=1, EN_I=1, EN_D=1 (PID operation)
⑨ REF, TT, N : REF=10, TT=5-, N=1
⑩ MV_MAX, MV_MIN, MVMAN : MV_MAX=4000, MC_MIN=0, MAMAN=2000
⑪ S_TIME : S_TIME=100 (sampling time = 10 seconds)
2) Auto-tuning parameters
① PV setting : 1600 (100°C)
② S_TIME : S_TIME=100 (sampling time = 10 seconds)
Power converter
Signal converter
Electric oven
(0 ~ 200°C)
heater
GM6 -
PAFB
+5V
+15V
K3P-
07BS
or
K3P-
07CS
Input
module
Output
module
A/D
module
Input
module
D/A
module
Output
module
Temperature
sensor
PV : DC4 ~ 20mA
(1 ~ 5V)
MV : DC4 ~ 20mA
(1 ~ 5V)
RS-232C
KGL-WIN
(V1.3 or later)