Chapter 12 Memory Module
12-7
12.1.4 How to use when password is set
(1) When connecting PADT with memory module
(a) When setting password at program and writing program to memory module, it is saved according to
rotary switch operating mode without functions cancelling the password
1) When writing program, check whether to use password at „Write‟ window.
2) If you press „OK‟ after setting password, program is saved at memory module with that
password.
(b) When reading password-set program to PADT, screen appears, which is same as when password is
set in PLC.
1) “Password” window is created.
2) If you input password same as that in memory module, it reads program.
3) When password is incorrect, error message appears as follows.
To Next Page
Loading...