LSIS XBC-DR14E - Appendix 4 Instruction List; Appendix 4.1 Classification of Instructions

Appendix 4 Instruction List
App. 4-1
Appendix 4 Instruction List
Appendix 4.1 Classification of Instructions
Classification
Instructions
Details
Remarks
Basic
Instructions
Contact Point Instruction
LOAD, AND, OR related Instructions
Unite Instruction
AND LOAD, OR LOAD, MPUSH, MLOAD, MPOP
Reverse Instruction
NOT
Master Control Instruction
MCS, MCSCLR
Output Instruction
OUT, SET, RST, 1 Scan Output Instruction, Output Reverse
Instruction (FF)
Sequence/Last-input
Preferred Instruction
Step Control Instruction ( SET Sxx.xx, OUT Sxx.xx )
End Instruction
END
Non-Process Instruction
NOP
Timer Instruction
TON, TOFF, TMR, TMON, TRTG
Counter Instruction
CTD, CTU, CTUD, CTR
Application
Instructions
Data Transfer Instruction
Transfers specified Data, Group, String
4/8/64 Bits
available
Conversion Instruction
Converts BIN/BCD of specified Data & Group
4/8 Bits
available
Data Type Conversion
Instruction
Converts Integer/Real Number
Output Terminal Compare
Instruction
Saves compared results in special relay
Compare to
Unsigned
Input Terminal Compare
Instruction
Saves compared results in BR. Compares Real Number,
String & Group. Compares 3 Operands
Compare to
Signed
Increase/Decrease
Instruction
Increases or decreases specified data 1 by 1
4/8 Bits
available
Rotate Instruction
Rotates specified data to the left and right,
including Carry
4/8 Bits
available
Move Instruction
Moves specified data to the left and right, word by word, bit
by bit
4/8 Bits
available
Exchange Instruction
Exchanges between devices, higher & lower byte, group
data
BIN Operation Instruction
Addition, Subtraction, Multiplication & Division for Integer/
Real Number, Addition for String, Addition & Subtraction for
Group
BCD Operation Instruction
Addition, Subtraction, Multiplication, Division.
Logic Operation Instruction
Logic Multiplication, Logic Addition, Exclusive OR, Exclusive
NOR, Group Operation
System Instruction
Error Display, WDT Initialize, Output Control, Operation
Stop, etc.
Data Process Instruction
Encode, Decode, Data Disconnect/Connect, Search, Align,
Max., Min., Total, Average, etc.
Data Table Process
Instruction
Data Input/Output of Data Table
String Process Instruction
String related Convert, Comment Read, String Extract,
ASCII Convert, HEX Convert, String Search, etc.
Special Function
Instruction
Trigonometric Function, Exponential/Log Function, Angle/
Radian Convert, etc.
Data Control Instruction
Max/Min Limit Control, Dead-zone Control, Zone Control
Time related Instruction
Date Time Data Read/Write, Time Data Adjust & Convert
Diverge Instruction
JMP, CALL
Loop Instruction
FOR/NEXT/BREAK
Flag related Instruction
Carry Flag Set/Reset, Error Flag Clear
Special/Communication
related Instruction
Data Read/Write by BUSCON Direct Access
Interrupt related Instruction
Interrupt Enable/Disable
Signal Reverse Instruction
Reverse Integer/Real Signals, Absolute Value Operation
File related Instruction
Blcok Read/Write/Compare/Convert, Flash data
Transmission
www.behaotomasyon.com
www.behaotomasyon.com