11
fault detection can be realized through the client, too.
⚫ Software Acquisition
This Windows Client has been pre-stored in the USB flash drive provided along
with the lidar. It can also be obtained from the sales or technical support
personnel. No installation is required to the Client.
⚫ Operating Environment
This software can only run under the Windows x64 operating system at present.
The computer configuration requirements for installing the software are: CPU:
Intel(R) Core (TM) i5 or higher; Graphics Card: NVIDIA GeForce GTX750 or
higher achieves the best effect, otherwise the display of the point cloud may be
affected. And the computer graphics card must support OpenGL 2 or higher
graphics acceleration to display the point cloud normally.
⚫ Supplemental Software
To use the Windows Client, it is necessary to install the WinPcap third-party
library. This software has also been pre-stored in the USB flash drive provided
with the lidar.
To install the WinPcap software, please follow the following steps:
Step 1. Insert the USB driver into the computer port and open it.
Step 2. Find the WinPcap installation file and double-click it to initiate the
installation.
Step 3. Click “next” to enter the installation path selection interface.
Step 4. Click “next” to enter the installation interface.
Step 5. Click the “install” button, and wait for the installation to be completed.
ROS Driver Program (optional): to view the point cloud data under Linux
operating system. This program has been pre-stored in the USB flash drive
provided with the lidar. It can also be obtained from the sales or technical
support personnel. No installation is required.
4. Usage Guide
This part states the operation instructions of the LSC32 Windows Client and
ROS driver presented by the LeiShen Intelligent System Co. Ltd.
To Next Page
Loading...
