42
Among which, T
Point_end
(N) indicates the end time of the N-th data point.
Appendix A. Maintenance
Shipping Requirements
C32 series lidars use the packaging materials specially customized by our
company, which can resist certain vibration and impact. For long-distance
transportation, special packaging materials must be used to avoid irreversible
damage during transportation.
Installation
Use screws that meet the specifications to fix the lidar base, and make sure the
base has good heat dissipation. Wear powder-free clean gloves during
installation to avoid optical cover contamination and mechanical damage.
Storage Conditions
The storage temperature of C32 series products is -40°C ~ 85°C. It is
recommended to store the products in a ventilated and dry place where the
temperature is 23±5°C, and the relative humidity is 30% ~ 70%. Do not store in
environments where humidity, pH, etc. exceed the protection level.
Dirt Treatment
If the mask is dirty during use, such as with fingerprints, muddy water, dry leaves
or insect corpses, etc., the lidar’s ranging effect will be directly affected. Please
clean it according to the following steps:
Tools: PVC gloves, clean cloth, absolute ethanol (99%)
Environment: ventilated and dry, away from fire
(1) Put on PVC gloves and fix the lidar base with your fingers; if it is not stubborn
stains, use a dust-free cloth or dry air to gently remove the stains;
(2) For stubborn stains, evenly spray the ethanol in the spray bottle on the
location to be cleaned and wait for the stain to be dissolved. Then use a dustless
cloth dipped in ethanol solvent, and gently wipe the mask. If the cloth is
contaminated, please replace it in time. After cleaning the stain, use a new
dustless cloth to remove any remaining liquid.
Appendix B. Power Supply Requirements
This lidar’s power input range is 9 V～36 VDC. If other DC power supply is
adopted, the recommended output voltage is 12 V, 19 V, 24 V or 32 VDC. The
output ripple noise should be <100 mV (Vp-p) and output voltage accuracy <5%.
The output power should be ≥25 W, for the lidar requires a large instantaneous
To Next Page
Loading...