Lu UNO - Required Items for the Installation

6
REQUIRED ITEMS FOR THE INSTALLATION
The following items are not included in the box :
All the material needed for structural hanging on the ceiling depending of construction type (ex. Cantruss,
1/2” [13 mm] threaded rod, bolts and nuts, etc.).
Security steel cables and fasteners to secure components directly to building structure, second safety,
3/16” (5 mm) cable for the main unit and 3/32” (2.5 mm) cable for the projector (length to be determined by
the installer).
Self-drilling #8 2/3” (19 mm) metal screws (3 minimum).
Lift system for persons (ex. scissor lift or scaffolding).
Tools (cable cutter, hex key [5 and 6 mm], wrench [7/16” and 3/4” at minimum], portable band saw and
small angle grinder with metal cutting wheel).
DN 40 (1 1/2”-11.5 NPS) threaded pipe for hooking the projector module (length to be determined by the
height of ceiling; the bottom part of the projector should be at 20’ [6 m] from ground).
DN 40 (1 1/2”-11.5 NPS) threaded pipe for hooking the camera module (length to be determined by the
height of ceiling; the bottom part of camera should be at 18’ [5.5 m] from ground).
2 celling plates (6 x 6” [150 x 150 mm]) or 8 x 8” [200 x 200 mm]) for receiving the projector and camera
threaded pipes.
1 12’ (3 m) RJ45 network cable
Pump to inate balls.
01
06
07
08
09
02
03
05
04
10