31
Click on “Ready” to test the lighting system. Make sure the lights match the colors shown.
Click on “Ready” to test the moving (or robotic) lights. Make sure both xtures in each lighting unit are
working.
If one or more lights are not working, make sure you have connected the DMX cables properly or contact the
technical support team.
Click on “Ready” to test the sound system.
If you do not hear any music during the test, make sure the cables are securely plugged in and that the
speakers are plugged in and turned on. If the problem persists, contact technical support.
Make sure that the projection quality is good in all 4 corners, that the focus is perfect, and that the projection
system is properly secured.
Make sure the volume of both speakers is the same (it should be set to 0 dB on both speakers).
Simulate a power outage (clearly identify which breaker you need for a restart) and ensure that the system
restarts properly and normally.
Make sure that the rods are securely fastened and cannot rotate and that the safety cables are in place.
Use a clean, damp cloth to wipe any dust or marks off the system.
02
03
02
03
04
05
LIGHTING AND SOUND
01
01
01
02
Lighting
Sound
K. Final check
System diagnosis
If you see “All good,” click on “Activate.” If an error has been agged and you are unable to correct the
situation, please contact Lü at 1-855-781-0797 to resolve the issue before activating.
To Next Page
Loading...