Luminex GigaCore Series - Page 32

32
Settings
The setting page allows you to assign the following PoE parameters to the ten front ports :
■ Enable / Disable PoE per port
■ Assign a priority on the port
To change the PoE parameters of one or several ports, please apply the following procedure :
■ 1- Select the port(s) you wish to modify
■ 2- Enable or disable these port(s)
■ 3- Select a priority for the port(s)
■ 4 -Apply your new parameters
1
2
3
4
The priority of a port is used when the switch reaches the limit of its maximum output power.
In the unlikely situation of PoE devices requiring too much power to the switch, the switch will rst disable the port(s)
with the lowest priority.