Luminex GigaCore Series - Status Page

23
Main menu :
On the left hand side, you can nd the main menu. Click on any tab to reach the corresponding menu.
Port status :
This table gives you a quick overview of the switch’s ports settings. Parameters such as port speed and legend can be
modied in the following menu: Global > Port Settings (see “Port settings” on page 25)
IP Settings :
Find here all the network settings of the switch. These parameters can be modied in the following menu: Global >
Device Settings (see “Device setttings” on page 24)
System Info :
Find here all the device’s info such as serial number, device name, system identier, MAC address, system description, and
if a conguration prole is currently in use. These information can be modied in the following menu:
Global > Device Settings (see “Device setttings” on page 24)
Switch image :
The top image gives you a quick overview of the switch port status (front and rear). Actives ports are lled with the
following colours:
■ Orange: 100Mbps link
■ Green: 1000Mbps (1Gbps) link
The status page is split into several panes that will be described below:
Status Page
Wink:
The feature allows you to easily identify a GigaCore switch in a stack of device. Click on the Luminex Logo on the switch
image, all four status LEDs on the left hand side of the switch will start blinking three times.
RPSU connectors:
On the right hand side of the switch’s image, two squares indicates the status of the RPSU connectors (PSU and PoE).
Three dierents status colors are available:
NO RPSU CONNECTED
RPSU CONNECTED
POWER ERROR