Colibri Manual Ver. 4.2 Dec 2006
LX Navigation d.o.o. www.lxnavigation.si
24
• How to disable Active Sync ?
Do a right mouse click on the ActiveSync symbol in the task bar,
choose Connection settings and disable the serial port. (This is only
necessary with PCs having a single com port).
Problems caused by USB to 232 adaptors.
Normally a PC has more than one USB port. On first use of USB/232
adapter, the operating system will detect new USB device and the
Wizard will guide you through the setup process to load the driver for
specified USB/232 adaptor. After successfully installation of
USB/232 driver, LXe will detect a new additional com port. Usually
the number of new comport is higher than 4 such as Com 5 or Com 6.
It is recommended that the same physical USB port on PC is always
used with the 232/USB adaptor. If you use another USB port, a new
installation of the USB/232 driver will be necessary, and the operating
system will allocate the next free com port.
The recommended LXe settings for safe and effective communication are:
• Use a fixed baud rate
• Use 19200 bps
• Keep the Colibri connected during preparation....
• If problems are experienced downloading flights, after the selected flight has been highlighted, and the
following symptoms are experienced;
Disabled ActiveSync
To Next Page
Loading...
Need help?
General
