LXNAV Nano3 - Communication; Enl; Sounds; Version 2.06 February

Version 2.06 February 2017
Page 29 of 44
Vario submenu allows you to adjust the Vario filters for the Vario needle and the vario
sound, the time constant for average vario and vario tape range.
5.7.7.3 Communication
In the communication menu, you can enable or disable the Bluetooth device, enable or
disable NMEA output on the USB port, baudrate for external serial interface.
Communication enables you to set the way NANO
3
will communicate with the Flarm. With
Target data NMEA you can enable NMEA data reception (GPRMB and LXVTARG) from other
external GPS devices (Oudie, GPS loggers,..). Target data source enables the NANO
3
to
communicate all information about the current target, depending on which page you are
(Task or Waypoint). AUTO option automatically detects the page mode (whether you are in
Task or Waypoint page) and send information about your current target.
5.7.7.4 ENL
This page is just for monitoring the engine noise level.
5.7.7.5 Sounds
In this menu various setting for sounds can be adjusted. Volume of vario sound, enabling of
system sounds and enabling of vario sounds. From version 1.5 here is also sound setting
for Flarm warning.
Vario volume can also be adjusted using rocker button, but only in GPS info page.