www.lynxspring.com
®
USER GUIDE
Lee’s Summit, MO 64086
sales@lynxspring.com
All Rights Reserved
Revised 2/1/2019
JENE-EG534-V2
Page 4 of 31
The following are addenda to Niagara Documentation: docJaceStartup and docPlatform
JACE Start Up Addendum
Please note the following amendments to Niagara Documentation “docJaceStartup” in regard to the operation of the
JENEsys Edge 534. Referenced Niagara documentation is included in the installation of ProBuilder™ or Niagara
Framework® and is typically located in a directory on the user’s PC, similar to: C:\JENEsys\JENEsys-3.8.111\docs
Pg. 3 - IP Address:
The JENEsys Edge 534 is shipped with a default address in the range of: 192.168.1.12n, like the JACE-3E,
JACE-6E, JACE-2/6 series.
Pg. 6 – Preparing to commission a new controller (Step 3):
Attach the cable to the primary Ethernet connector.
Pg. 14 - Starting the commissioning Wizard (Step 5):
Please refer to the screen below:
Pg. 15 - Starting the commissioning Wizard (Step 8):
Please refer to this screen below:
Pg. 46 - System Shell:
The JENEsys Edge 534 System Shell will be accessible using the Mini USB port, rather than an RS-232 port.
About the JACE System Shell Menu:
The Shell menu of the JENEsys-Edge 534 does not include the ability to enable/disable SFTP and
Telnet.
Pg. 50 - About serial shell mode - Items Needed for Serial System Shell:
An RS-232 port on your PC is not needed.
The JENEsys-Edge 534 will only require a Mini-USB to USB cable and terminal emulation software
installed on your PC.
The JENEsys-Edge 534 does not use a jumper.
To Next Page
Loading...
Need help?
General
