www.lynxspring.com
®
USER GUIDE
Lee’s Summit, MO 64086
sales@lynxspring.com
All Rights Reserved
Revised 2/1/2019
JENE-EG534-V2
Page 11 of 31
Onyxx Network views
The default view of the onyxxNetwork is the ‘N Device Manager.’ This is the equivalent of the ‘Device Manager’ in most
other drivers. Use this view to discover and add Onyxx Device components to the station. For details, see
“N Device Manager” below. Other standard views are also available on the onyxxNetwork.
N Device Manager
As the default onyxxNetwork view, the ‘N Driver Device Manager’ view can be used to discover and add one or more
“device-level” Onyxx Device components to the station’s database (
Figure 3-4). For general information, refer to
“About the Device Manager” in the Drivers Guide.
Figure 3-4 Adding Onyxx Device discovered using N Device Manager
Figure 3-5 Add dialog for Onyxx Device(s)
Onyxx Board Manager Usage notes
Before launching a discover job, ensure that any external I/O modules are correctly installed and connected to
the host JENEsys Edge 534 controller. When adding the device to the database, changes to any defaults
other than “Name” is not needed (
Figure 3-5).
To Next Page
Loading...
Need help?
General
