84
Wheels
Editing Assignments
You can set the channel of each wheel. See Channel to learn how to do this.
To learn how to assign a MIDI CC message to a wheel, see the Messages section.
Channel
To set the MIDI channel for a wheel:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Move the desired wheel. PW (pitch-bend wheel) or MW (modulation wheel) will appear in
the display.
3. Press the Chan Assign key. The display will show CHN for 1 second and then show PW
or MW and current MIDI channel or zone channel.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter the desired MIDI
channel (00 or 01–16) or zone channel (17–20).
Note: Values 00 and 01–16 correspond to Code 61’s global channel and the 16 available
MIDI channels. Values 17–20 correspond to channels used by Zones 1–4 (z1–z4).
5. Press the Enter key. The wheel will be assigned to that channel, and you will exit Edit
Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
To Next Page
Loading...
Need help?
General
