87
Messages
MIDI CCs
You can assign the sustain pedal to send a MIDI CC message when you press it.
To assign a MIDI CC to the sustain pedal:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the sustain pedal. SUS will appear in the display.
3. Press the Ctrl Assign key. The display will show ASGN for 1 second and then show SUS
and a number for the type of message it sends.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a MIDI CC number
(001–127).
5. Press the Data 2 key. The display will show DATA2 for 1 second and then show SUS and
the value it will send when released.
6. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (001–127).
7. Press the Data 3 key. The display will show DATA3 for 1 second and then show SUS and
the value it will send when pressed.
8. Use the numeric keys (0–9) or Preset Down/Up (
) buttons to enter a value (001–127).
9. Press the Enter key. The sustain pedal is now set to send the assigned MIDI CC, and you
will exit Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
To Next Page
Loading...
Need help?
General
