93
Latching
By default, the sustain pedal is set to send one value when pressed and one value when
released. This is often called “momentary” behavior. You can change this so that the sustain
pedal sends one value when pressed and a different value when pressed a second time,
alternating between the two values with each press. This is often called “latching” or “toggle”
behavior.
To set the sustain pedal to latching behavior:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the sustain pedal. SUS will appear in the display.
3. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter 146 (if the display
does not already show it). This sets the sustain pedal to use latching behavior.
4. Press the Data 1 key. The display will show DATA1 for 1 second and then show SUS and
a number for the MIDI CC.
5. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter the desired MIDI
CC number (001–127).
6. Press the Data 2 key. The display will show DATA2 for 1 second and then show SUS and
the value it will send when pressed the first time.
7. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter the desired value
(001–127).
8.
Press the Data 3 key. The display will show DATA3 for 1 second and then show SUS and
the value it will send when pressed the second time.
9. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter the desired value
(001–127).
10. Press the Enter key. The sustain pedal is now set to latching, and you will exit Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
To return the sustain pedal to its default “momentary” behavior, assign it to a MIDI note or
MIDI CC as described in the earlier Message section.
To Next Page
Loading...
Need help?
General
