98
MIDI Out
The MIDI Out port sends out MIDI messages from your Code Series keyboard. You can
enable or disable this port. By default, it is disabled. It will not send out incoming MIDI
messages from your DAW or the MIDI In port.
To enable or disable the MIDI Out port:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the MIDI Out key to enable or disable the port. The display will show MID and
whether the port is ON or OFF.
To change it while the display still shows the state, press the MIDI Out key or a Preset
Down/Up () key to switch between ON or OFF.
To confirm your change, wait for 1 second. You will exit Edit Mode automatically.
MIDI Panic
If you are experiencing “stuck” notes (notes that will not stop playing), you can send a “MIDI
Panic” message. This means all MIDI notes will stop and all controls will stop sending their
messages.
Press and hold Shift and press Transpose to send a MIDI Panic message.
To Next Page
Loading...
Need help?
General
