90
Program, Bank LSB, and Bank MSB
You can set the sustain pedal to send a combined program number, Bank LSB, and Bank
MSB number. This can be useful for selecting a preset from a specific bank of a virtual
instrument or synthesizer (the instrument or synthesizer must support these messages).
To
assign the sustain pedal to send a combined program, Bank LSB, and Bank MSB number:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the sustain pedal. SUS will appear in the display.
3. Press the Ctrl Assign key. The display will show ASGN for 1 second and then show SUS
and a number for the type of message it sends.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter 145.
5. Press the Data 1 key. The display will show DATA1 for 1 second and then show SUS and
the program number it will send.
6. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter the desired
program number.
7. Press the Data 2 key. The display will show DATA2 for 1 second and then show SUS and
the Bank LSB number it will send.
8. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter the desired Bank
LSB number.
9. Press the Data 3 key. The display will show
DATA3 for 1 second and then show SUS and
the Bank MSB number it will send.
10. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter the desired Bank
MSB number.
11. Press the Enter key. The sustain pedal is now set to send the combined program, Bank
LSB, and Bank MSB number, and you will exit Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
To Next Page
Loading...
Need help?
General
