M-Audio code25 User Manual

92
MMC (MIDI Machine Control)
Some recording hardware and DAWs can be controlled remotely via MMC (MIDI Machine
Control) messages. MMC is a transport control protocol.
To assign a MMC message to the sustain pedal:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the sustain pedal. SUS will appear in the display.
3. Press the Ctrl Assign key. The display will show ASGN for 1 second and then show SUS
and a number for the type of message it sends.
4. Use the numeric keys (0–9) to enter 149 (if the display does not already show it). This sets
the sustain pedal to send MMC messages.
5. Press the Chan Assign key. The display will show DEV ID for 1 second and then show
SUS and the current MIDI channel it uses.
6. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter 127.
7. Press the Data 2 key. The display will show DATA2 for 1 second and then show SUS and
the number for its MMC message (if any):
001
Stop
008
Record Pause
002
Play
009
Pause
003
Deferred Play
010
Eject
004
Fast-Forward
011
Chase
005
Rewind
012
MMC Reset
006
Record Strobe (Punch In)
007
Record Exit (Punch Out)
8. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter the number of the
desired MMC message.
9. Press the Enter key. The sustain pedal is now set to send the assigned MMC message,
and you will exit Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.

M-Audio code25 Specifications

General

Brand	M-Audio
Model	code25
Category	Recording Equipment
Language	English