MacDon M100 2009 - Page 78

HEADER OPERATION – D SERIES
Form # 169304 78 Model Year - 2009
6.5.4.2 Draper Minimum Speed
Set the minimum draper speed as follows:
IMPORTANT
Windrower cannot be moving.
NOTE
This procedure can also be used to
change the draper speed “on the go”.
These changes become the new set-
points.
CAUTION
Check to be sure all bystanders have cleared
the area.
NOTE
DISPLAY will flash ##.# MIN CONV (MPH
or KPH) to prompt the operator to change
the minimum set point or increase ground
speed if Ground Speed Plus Index is less
than the Minimum Draper Speed Set
Point.
6.5.4.3 Draper Speed Independent of Ground
Speed
Set the speed of the draper independently of
ground speed as follows:
NOTE
This procedure can also be used to
change the draper speed “on the go”.
CAUTION
Check to be sure all bystanders have cleared
the area.
##.# = MPH or KPH
ENGAGE HEADER
ON CDM PRESS
FAST OR SLOW
DISPLAY SHOWS
##.# DRAPER MIN
DONE
SPEED
O.K.?
NO
YES
PRESS DISPLAY SELECTOR
FOR DRAPER MIN
HEADER INDEX
SWITCH - ON
##.# = MPH or KPH
ENGAGE HEADER
ON CDM PRESS
FAST OR SLOW
DISPLAY SHOWS
##.# DRAPER SPEED
DONE
SPEED
O.K.?
NO
YES
PRESS DISPLAY SELECTOR
FOR DRAPER SPEED
HEADER INDEX
SWITCH - OFF
DISPLAY
SELECTOR
DISPLAY
HEADER INDEX
FAST
SLOW