INSTALLATION INSTRUCTIONS
3.2 Installing Traction Drive Test Fittings
The test fittings are installed to a id in any future neutral adjustments that may be required.
1. Locate the four p lugs (A) th at will be replaced with
fittings on the traction drive pump assembly (B).
Figure 3.8
: Location o f Three Plugs
Figure 3.9: Location of One Plug
2. Using a 3/4 in. wrench, remove one ORB plug (A) from
the traction drive pump assembly.
NOTE:
It may be difficultytoengageatorquewrench
onto the flats of the fitting; if so, lanyard holder
may be bent up slightly in order to provide
additional clearance for a w rench.
Figure 3.10: Traction Drive Pump Assembly
167730
12
Revision B
To Next Page
Loading...
