MACROMEDIA FLASH 8-FLASH LITE 2.X ACTIONSCRIPT LANGUAGE - Getpowersource Fscommand2 Command; Getsignallevel Fscommand2 Command

fscommand2 Commands 237
GetPowerSource fscommand2 Command
GetPowerSource
Returns a value that indicates whether the power source is currently supplied from a battery or
from an external power source.
Availability: ActionScript 1.0; Flash Lite 1.1
Example
The following example sets the
myPower variable to indicate the power source, or to -1 if it
was unable to do so:
myPower = fscommand2("GetPowerSource");
GetSignalLevel fscommand2 Command
GetSignalLevel
Returns the current signal strength as a numeric value.
Availability: ActionScript 1.0; Flash Lite 1.1
Example
The following example assigns the signal level value to the
sigLevel variable:
sigLevel = fscommand2("GetSignalLevel");
Command Parameters Value Returned
GetPowerSource None -1: Not supported. 0: Device is operating on
battery power.
1: Device is operating on an
external power source.
Command Parameters Value Returned
GetSignalLevel None -1: Not supported. Other numeric values: The
current signal level, ranging from
0 to the
maximum value returned by
GetMaxSignalLevel.