OPERATING MATERIALS
OILS
106 Maintenance manual T225/T230
Transmission oil
For the transmission, use ATF transmission oils with the
specification TES 389 or DEXRON III.
When using TES 295 (synthetic transmission oil), the oil
change interval can be extended to 2000 operating hours or
the oil change done at least every two years.
In our plant, the MT has been filled with transmission
oil of the specification DEXRON III.
Axles
At our plant, an oil of the quality GL5 with the viscosity class
SAE 90 is used for filling.
Fig. 75: SAE classes of transmission oil
Fig. 75 shows which viscosity classes can be used in the
various temperature ranges.
The temperature values refer to constant ambient air
temperatures.
Hydraulic oil
For the hydraulic system use hydraulic oil of the HLP-ISO-VG
specification.
Fig. 76: Viscosity classes for hydraulic oil
Fig. 76 shows which viscosity classes can be used in the
various temperature ranges.
Observe the manufacturer's specifications on hydraulic
oil. At our plant, a hydraulic oil with the viscosity class
ISO VG 46 has been used for filling.
To Next Page
Loading...
